4-Inch Aluminum Vise Jaw Pads for Clamping Round Stock, Made in USA

4" Aluminum Barrel Vise Jaw Pads — 1 Pair — Made in USA

Precision-machined aluminum barrel vise jaw pads / soft jaws for clamping barrels, shafts, and round stock from 0.375" to 0.750". Built for a secure, repeatable hold while helping protect finishes when used correctly.

Includes: 1 pair / 2 jaw pads   |   Length: 4"   |   Made in: Larwill, Indiana USA

Built for Better Barrel and Round Stock Clamping

These 4" aluminum barrel vise jaw pads are made for users who want a solid hold without relying on cheap, soft import pads that can slip, deform, or wear out quickly. The machined aluminum body gives you a repeatable clamping surface for barrel work, shafts, and similar round stock holding jobs.

• Precision machined for consistent clamping and repeatable fit.
• Aluminum soft-jaw design helps reduce marking compared with bare steel jaws.
• 4" long clamping surface gives more contact area than short jaw inserts.
• Made in Larwill, Indiana by a USA manufacturer, not a drop-ship reseller.
• Useful beyond barrel work for shafts, pins, rods, and round stock in the shop.

Item	Barrel vise jaw pads / soft jaws
Quantity	1 pair / 2 pads
Length	4 inches
Material	Machined aluminum
Fit Range	0.375" to 0.750" barrels / shafts / round stock
Finish Protection	Non-marring soft-jaw contact when used correctly
Origin	Made in USA — Larwill, Indiana

Common Uses

Barrel vise work, gunsmithing setup, shaft holding, pin and rod clamping, round stock workholding, and general shop use where a clean aluminum clamping surface is preferred.

Made in the USA Means Accountability

Many jaw pads on eBay are low-cost imports. These are made in the USA for buyers who value American machining, consistent quality control, and a tool that is built to last.

What You Get

1 Pair of 4" Aluminum Barrel Vise Jaw Pads

Always verify fit for your specific vise, barrel, shaft, or workholding setup before use. Use proper shop and gunsmithing safety practices.